UNISIG’s addition of the Okuma MCR-A5CII-35×100 allows the rapid machining of complex components that go into our precision deep hole drilling machines. The new machining center

deep hole drilling facility

Double Column Machining Center Expands UNISIG Capabilities

UNISIG’s addition of the Okuma MCR-A5CII-35×100 allows the rapid machining of complex components that go into our precision deep hole drilling machines. The new machining center is the largest double-column machine of its type in North America, and features multiple heads that allow processing on five sides with a single setup, resulting in time and cost savings in key machine components, while maintaining the highest standards of accuracy. To support the new Okuma machine, a Konecranes 50-ton crane has been installed, along with climate control technology.

Share this story!